Skip to main content
Monday, November 16, 2026Nov 16

Watts Bar Nuclear Plant shows it can perform under pressure

watts-bar-nuclear-plant-shows-it-can-perform-under
watts-bar-nuclear-plant-shows-it-can-perform-under
photo The nuclear power plant towers at Watts Bar are reflected in Watt’s Bar lake during a clear late evening sun set.

About Watts BarSite: Located on a 1,770-acre site near Spring City, Tenn., just below the Watts Bar Dam on the Tennessee RiverOwner: Tennessee Valley AuthorityPlant design: Two Westinghouse pressurized water reactors, each capable of generating about 1,200 megawatts of powerHistory: Construction began in 1973 but was suspended in 1988 when power demand slowed. Unit 1 was finished on 1996 and work resumed on Unit 2 construction in 1999.Status: Unit 2 is more than 90 percent completeInvestment: More than $10 billion in both units, including capitalized interest expenses over the past 40 yearsPath to power productionThe key milestones remaining before the Unit 2 reactor is finished include:* October 30, 2014 – NRC commission hearing to update construction and testing work* December, 2014 – NRC safety evaluation report is due* January, 2015 – Operational readiness assessment of plant will be completed* February, 2015 – Advisory Commission on Reactor Safety does final review of Watts Bar* March, 2015 – Readiness letter from NRC staff and TVA officials for plant licensing* April, 2015 – NRC commission decision on granting an operating license for Unit 2* Spring of 2015 – Nuclear fuel is loaded in Unit 2* December 2015 – Start up and power generation beginsSources: Nuclear Regulatory Commission, TVA

Arkansas-St. John’s Live Blog

Four decades after workers began construction of the Watts Bar Nuclear Plant, TVA successfully passed a critical test this week toward finally completing a second reactor at the Spring City, Tenn., power plant.

TVA workers and contractors on Tuesday successfully completed a cold hydro-static pressure test to ensure that key reactor equipment and systems did not leak or fail under pressure in the Unit 2 reactor under construction at Watts Bar.

“This is a significant milestone and success for Watts Bar yesterday to ensure that the workmanship used to construct the reactor coolant system and other associated systems were constructed in the right manner,” said Ray Hruby, general manager for Watts Bar Unit 2 construction services.

Hruby and other TVA officials on Wednesday briefed top regional officials with the Nuclear Regulatory Commission on the status of Watts Bar.